GE LOGIQ E9 Service Manual page 335

GE
D 5573152-100, R
IRECTION
8-5-12 Rear Cover replacement
NOTE: When replacing Rear Cover Assembly for a LOGIQ E9 used in veterinary environment, the
LOGIQ E9 Spare Parts Handling for Veterinary Systems MUST BE re-installed before the
LOGIQ E9 returned for use. See:
Veterinary Environment" on page 8-48
consoles used in a veterinary environment" on page
If the V Nav On-Board Stand Option is present on the LOGIQ E9, the Option must be removed to
remove the Rear Cover. See:
8-12-5 "Assembling or replacing the On-Board V Nav Stand" on page
8-5-12-1 Manpower
One person, 15 minutes.
8-5-12-2 Tools
For tools needed, refer to:
8-5-12-3 Preparations
When preparing for the replacement, you must perform the following steps:
1.) Power down the system
2.) Disconnect the mains power cable from the wall outlet.
3.) Disconnect all Probes and External I/O Cabling.
4.) Remove the Rear Bumper.
5.) Remove both Side Covers.
6.) Remove Filter Cover at rear.
7.) Remove Filter.
Follow these links if you need more information:
• 4-2-3 "Power shut down" on page 4-6.
• 8-5-3 "Side Covers replacement" on page 8-28.
• 8-5-10 "Filter Cover replacement" on page 8-49.
• 8-7-2 "Rear Filter and "handle type" Bottom Filter replacement / cleaning" on page 8-185.
. 2
EV
8-5-9-5 "Label Placement for the LOGIQ E9 used in a
8-2-5 "Tools needed for servicing the LOGIQ E9" on page
Chapter 8 Replacement procedures
and Section 9-20 "Product Labels on LOGIQ E9
9-122.
LOGIQ E9 S
ERVICE
8-302.
8-5.
M
ANUAL
8 - 51