GE LOGIQ E9 Service Manual page 322

GE
D 5573152-100, R
IRECTION
8-5-6 Side Bumpers replacement
Manpower /
Time
One person /
15 minutes
Table 8-16
1. Power down the system.
2. Disconnect the mains power cable from the wall outlet and all Probes and External I/O Cabling.
3. Remove the Side Cover(s).
Preparation Links (if you need more information):
• 4-2-3 "Power shut down" on page 4-6.
• 8-5-3 "Side Covers replacement" on page 8-28.
8-5-6-1 Side Bumpers removal
1. Unscrew and remove the six screws and washers that fasten the Side Bumper to the Side Cover.
Remove the Side Bumper from the Side Cover.
8-5-6-2 Side Bumpers installation
1. Align the fastening holes in the Side Bumper with the holes in the Side Cover.
Fasten the screws with washer, one by one until all have been inserted.
Tighten the screws.
2. Install the Side Cover(s).
8 - 38
. 2
EV
Table 8-15 Manpower / Time and Tools
Refer to:
8-2-5 "Tools needed for servicing the LOGIQ E9" on page
Preparations and Preparation Links
Preparations - you must perform the following steps
Table 8-17 Side Bumpers removal
Steps
Table 8-18 Side Bumpers installation
Steps
Section 8-5 - Replacing Covers and Bumpers
LOGIQ E9 S
Tools
Corresponding Graphic
Corresponding Graphic
M
ERVICE ANUAL
8-5.