Routine Maintenance - GE LOGIQ E9 Service Manual

Hide thumbs Also See for LOGIQ E9:

Table of Contents

5573152-100, R

Routine Maintenance

1.) Periodically inspect all fasteners associated with the mounting system. Tighten them as necessary

for optimal operation and safety.

DO NOT overtighten any fasteners.

Cleaning the Mounting Assembly

1.) The mounting assembly may be cleaned with most mild, non-abrasive solutions commonly used in

the hospital environment (e.g., diluted bleach, ammonia, or alcohol solutions).

2.) The surface finish will be damaged permanently by strong chemicals and solvents such as acetone

and trichloroethylene.

3.) Do not use steel wool or other abrasive material to clean the mounting assembly.

4.) The damage caused by the use of unapproved substances or processes will not be covered by

warranty. It is recommended to testing any cleaning solution on a small area of the mounting

assembly, that is not visible, to verify compatibility.

5.) Never submerge the roll stand nor allow liquids to enter the mounting assemblies. Wipe any

cleaning agents off of the mounting assembly immediately, using a water-dampened cloth. Dry all

mounting assemblies thoroughly after cleaning.

THE COMPANY MAKES NO CLAIMS REGARDING THE EFFICACY OF THE LISTED CHEMICALS

OR PROCESSES AS A MEANS FOR CONTROLLING INFECTION. CONSULT YOUR HOSPITAL'S

INFECTION CONTROL OFFICER OR EPIDEMIOLOGIST. TO CLEAN OR STERILIZE MOUNTED

INSTRUMENTS OR ACCESSORY EQUIPMENT, REFER TO THE SPECIFIC INSTRUCTIONS

DELIVERED WITH THOSE PRODUCTS.

Section 8-12 - V Nav Roll Stand and/or On-Board Stand Installation and/or Replacement