GE LOGIQ E9 Service Manual page 191

GE
D 5573152-100, R
IRECTION
6-3-4 LCD Arm and LCD Monitor Tilt adjustment - Daeil Arm
There are no adjustments for the Daeil LCD Arm.
If the Monitor is too loose or too tight when it is tilted, perform a Tilt adjustment.
Table 6-8
1. Tilt the Monitor down and remove
the Monitor Rear Cover.
If the Monitor is too loose, turn the
Adjustment Nut (A) towards the
back and Nut (B) towards the front
to increase the friction, using a
13 mm open-end wrench.
Turn the Nuts the opposite direction
to decrease the friction. The Monitor
should stay in the position it is
released at.
NOTE: Be sure to tighten or loosen
both sides equally. Start with 1/4
turn and test full 90 degree
movement before tightening or
loosening more.
Reinstall the Monitor Rear Cover.
. 2
EV
Monitor Tilt adjustment - Daeil Arm
Steps
Chapter 6 Service Adjustments
LOGIQ E9 S
Corresponding Graphic
M
ERVICE ANUAL
6 - 15