GE LOGIQ E9 Service Manual page 535

Hide thumbs Also See for LOGIQ E9:

Table of Contents

5573152-100, R

Table 8-158 4D MC Removal for Cherokee/Mitra PS

Disconnect the USB Cable from J28 on

Discard all the removed components.

Table 8-159 4D MC Re-installation for Cherokee/Mitra PS

NOTE: Before installing the 4D MC, write

down the part number, service number

and revision. These will be used later to

Guide the 4D MC into its location in the

Main PS and install the two screws

(circled) supplied with the replacement.

Make sure the Flex Cable to the Controller

Card lies behind the Flex Cable from the

Main PS as shown.

Connect the Flex Cable (2) to the Main PS

NOTE: The replacement 4D MC includes

a two USB Cables, the shorter USB Cable

must be used for a Cherokee/Mitra PS.

Connect the shorter USB Cable (1) to the

Use care when connecting the Flex Cable to the connectors. The connectors are fragile and will be

damaged if not installed properly.

Chapter 8 Replacement procedures

Corresponding Graphic