GE LOGIQ E9 Service Manual page 577

GE
D 5573152-100, R
IRECTION
8-12-2 Assembling or replacing the Roll Stand
Use these instructions to assembled or replace the Roll Stand.
1.) Insert the post in the base. The locator pin ensures correct alignment.
Figure 8-63 Post into Base - (1) 5/16 fLAT Washer, (2) 5/16 Lock Washer,
2.) Using the 1/2 inch socket wrench provided, fasten the post to the base with the hardware shown.
. 2
EV
(3) 5/16-18 x 1 inch Screw - Roll Stand only
1
2
3
Chapter 8 Replacement procedures
LOGIQ E9 S M
ERVICE ANUAL
8 - 293