GE LOGIQ E9 Service Manual page 192

GE
D 5573152-100, R
IRECTION
6-3-5 Monitor Arm and Monitor Friction Adjustment - Ergotron Arm
6-3-5-1 Monitor Arm Vertical adjustment
If the Monitor rises or falls when it is released, perform a Vertical adjustment.
Table 6-9
1. Tilt the Monitor down to access the
Vertical Adjustment Screw.
If the Monitor was rising, turn the
Adjustment Screw clockwise to
increase the friction, using a 4 mm
Allen wrench.
If the Monitor was falling, turn the
Adjustment Screw
counterclockwise to decrease the
friction.
The Monitor should stay in the
position it is released at.
NOTE: The heavier the Monitor, the
more friction will be required.
6 - 16 Section 6-3 - Monitor Arm and/or Monitor range of motion Adjustment procedure
. 2
EV
Monitor Arm Vertical adjustment
Steps
LOGIQ E9 S
Corresponding Graphic
Monitor Arm Vertical Adjustment Screw
M
ERVICE ANUAL