Symantec Ghost Window - GE LOGIQ E9 Service Manual

GE
D 5573152-100, R
IRECTION
Table 8-4
4. Press any key to continue; or to abort,
remove the disk from the drive and press
CTRL-C.
The System Software Load Instruction
window displays.
5. Choose Option 1 to perform a complete
Software installation, all data will be erased.
Choose Option 2 to install Software on C
partition only. Only data on C partition will
be erased.
Choose Option 1.
The Software loader program will begin to
launch and the following warning will
appear:
You are about to reload the
entire disk. If you DO NOT want
to do this, remove the CDROM from
the CDROM drive and Press
"CTRL-C" now to exit and power
cycle your system to restart
without overwriting your disk
drive's current contents.
Press any key to continue...
The Software loader program will continue
to launch.
In R5 or later, at some point the system will
prompt to insert Disk #2. Follow the screen
instructions.
The Symantec Ghost window displays.
WARNING WARNING
DO NOT interrupt the software loading at any time.
8 - 12
. 2
EV
Software Load
Steps
Section 8-4 - Loading / Reloading / Upgrading the Software
LOGIQ E9 S
Corresponding Graphic
System Software load
instruction (R.4)
After any key to boot DVD Ghost
Ghost wait until next

Symantec Ghost Window

M
ERVICE ANUAL