Quasar Surface - Modules' Discovery & Configuration - Axia Quasar User Manual

Hide thumbs Also See for Quasar:

Table of Contents

Now you need to access the System Setup page: push and hold for 5 seconds the Monitor Options

key (labeled "MON OPT" and located between the two Control Room volume pots). Here you will

need to assign an IP address to your console, as well as the Network Mask, and bind the surface to

the engine.

At the bottom of this page you can associate your Quasar Engine to the surface, by entering the

Engine's IP address. Addresses can be entered directly from the touchscreen, or by using the rotary

encoders below the display. A configured gateway is optional, and not required for normal console

operation in a closed network.

Press the "Save and Reboot" button when done. Once the Master Module IP address is set, you can

now access the console Web UI to configure each fader module's IP address.

Quasar Surface – Modules' discovery & configuration

Using a PC connected to your studio network, launch a web browser and enter the IP address you

previously assigned to the MTS into the browser's address bar.

Table of Contents