apply to the input signal when the specified Threshold is met.
Compressor Threshold
Select the Use: radio button to specify the ceiling, up to -30 dB, at which the
•
Compressor activates to attenuate input signals above that level.
Compressor Ratio
Select the Use: radio button to specify the aggressiveness of the compressor, up to 16:1.
•
De-Esser Threshold
Select the Use: radio button to specify the ceiling, up to -20 dB, at which the De-
•
Esser activates to attenuate sibilance.
De-Esser Ratio
Select the Use: radio button to specify the aggressiveness of the De-Esser, up to 8:1.
•
Compressor Mode
No Freeze: The compressor is "free" to operate no matter the input level.
•
Freeze: Prevents the compressor from "sucking up" room noise during brief pauses in
•
audio input.
Backward Feed Dim Gain
Select the Use: radio button to specify the amount of attenuation, up to -30 dB, will be
•
applied to program audio being fed back to this source (if it has an associated
Backfeed, such as an IFB or Talkback channel).
Channel On/Off Status
Safe ON: If the fader is ON, and the Show Profile specifies a new source be loaded to
•
this fader, the new source will be queued until the fader is turned off.
If the new source is the same as the old source, the fader is immediately turned ON
when the Show Profile loads.
Force OFF: Immediately turns the fader OFF when the Show Profile loads.
•
Force ON: Immediately turns the fader ON when the Show Profile loads. If a new
•
source is to be loaded to the fader, it is changed immediately, regardless of whether
audio from a previous source is passing through the fader.
Control Lock Map
PGM1 – PGM4, Options, Preview, On/Off, Fader, Talkback, HP Source: Place a
•
check mark in any of these boxes to keep the board op from changing the Show
Profile's pre-selected options for this fader.