Axia Quasar User Manual page 90

Select the Telos phone system you're interfacing with. You can choose from Telos 2, Nx-
Series (shown as AP (Nx12))or VX and enter the appropriate settings for the device.
•
If you're using a Telos TWO, enter the number of the line to be used in the Line box.
•
If using an Nx system, enter the Line and Hybrid numbers in their respective boxes.
Select the Use 2 nd Show check box if split shows are enabled on your phone system.
•
If using a VX system, enter the Studio Name as configured in your VX Engine, and the
number of the Fixed Hybrid.
» Select the Call Controller 1 radio button (if you have multiple Call Controllers
installed, select the appropriate one).
» In the Hybrid box, enter the hybrid number you want this Source Profile to be
associated with. This corresponds to the Channel ID number found in the Studio
Information page of the VX Web UI.
» The Fixed Line box is another method to do what the EU Phone method
accomplishes; i.e., assign- ing a dedicated line to a dedicated fader. Most
users with Call Controllers will not use this option. Leave this set to 0 if you are
using the Call Controller.
» The Mashing Allowed checkbox permits a single hybrid to handle multiple
callers at once by allow- ing the board operator to select multiple line buttons.
Check (or un-check) this box as you desire.
US Phone Call Controller is used in case you want US-Style control of a Telos Hybrid
system which is controlled over IP, and you're going to use the built-in soft Call Controller
to do so.