Table of Contents
Advertisement
From The Console:
Push the top encoder of the channel strip you want to load with a source, and select the Source tab in
the Master Touchscreen module.
Here you will be
presented with a list of
all the sources that
have been configured
on your console, and
are active onto the
network, and you will
be able to select one
by scrolling the
touchscreen and
pushing the Load
Source button on the
right.
Note: inactive sources
– those generated by
devices which are
disconnected from the
network, or switched
off – will not be
detected by the Quasar
and therefore will not
show up on the above
list.
From the Web UI:
From your PC, navigate the "Shows" main page, and create a New Show Profile
© 2016 Axia Audio - Rev 2.0
Advertisement
Table of Contents
