Axia Quasar User Manual page 62

Left / Right: takes the chosen side of the Monitor channel and sends it to both speakers.
•
Sum: Creates a sum of both sides of the Monitor channel and sends the sum to both
•
speakers.
CR Monitor Dim Gain
Select the Use: radio button to specify the amount of attenuation, up to -30 dB, to be
•
applied to the CR Monitor channel when Talkback or Preview are in use.
CR Monitor Muted State Gain
Select the Use: radio button to specify the amount of attenuation, up to -85 dB, to be
•
applied to the CR Monitor channel when muted.
NOTE: Normally, turning a Control Room microphone channel ON mutes the CR Monitor
speakers entirely. This setting allows you to let the monitors to be heard in the Control
Room at a reduced level, even while CR Mics are active.
GPIO Channel For CR Monitor
Enter the GPIO channel number used to trigger On Air lamps or other GPIO functions.
•
This option should typically be programmed with the same logic channel number for all
Show Profiles.
Control Room Headphones Options Section
Source
Use the radio buttons to choose the source that will be selected to feed the Control
•
Room headphones upon Show Profile load.
CR Headphones Master Gain
Select the Use: radio button to specify the level of the CR Headphones upon Show
•
Profile load. You may specify a value between -85 dB and 0 dB.
Signal Mode: CR Headphones
Stereo: sets Headphone channel to Stereo.
•
Left / Right: takes the chosen side of the Headphone channel and sends it to both
•
speakers.
Sum: Creates a sum of both sides of the Headphone channel and sends the sum to both
•
speakers.
CR Headphones Independent