Axia Quasar User Manual page 88

The Phone Type is where you select the protocol used to communicate with the call
server. Prior to the VX system, the AP protocol was used. The AP option is to support legacy
Telos products still in use, otherwise you would likely select the VX option.
The Phone Server IP is where you identify the IP address of the Telos product that is
managing the calls.
In case the standard access credentials are used (user: user , password: no password ),
just enter the VX IP address here.
In cases where the non-standard credentials are used, you would add those here using
the following syntax: user:password@xxx.xxx.xxx.xxx
The Show Name field is used to identify a phone system configuration when using a
Telos Series 2101 or VX system. These names are defined in your phone system's setup.
Enter the configuration name you wish your Call Controller to log into.
Note: with the VX system, this field can be left blank, permitting the changing of the
show assigned with a VSet phone, or the VX Web UI interface, or a remote control
connection.
If you set the show name here, upon connection the Quasar will select that show in
the VX.
If you don't, the VX will keep its current show configuration regardless of the Show
Profile loaded on the console.
The Host / Studio Name field is used differently with different systems.
With VX systems, use this field to define the "Studio" name. This information allows
•
the Quasar Call Controller to interface with the appropriate configuration as defined
in the VX. An incorrect name instructs the Quasar to connect to a non-existing
configuration, which is indicated by the text "Studio: NULL" displayed in the
INFORMATION field of the Call Controller.
In legacy Telos phone systems, this field is used to log into the appropriate
•
configuration:
» "Hybrid1", "Hybrid2", "Hybrid1&2" (used in TWO-x-12)
» "Hybrid 1&2", "Hybrid 3&4", "Hybrid 1-4" (used in Nx6 & Nx12)
The Show Password field is used to permit access between your Quasar console and
any Telos Call system that has password protection at show levels. If you have a password
for the phone system Show you want to use, enter it here.
The Telos VX system does not use a password to protect shows, so this field will be
completely ignored by a VX. You can leave it blank.
The Reversed Hybrid option swaps the banks of the Call Controller. By default, the left
column controls Hybrid 1, and the right column controls Hybrid 2; selecting this option
reverses these.