Table of Contents
Advertisement
Monitor Options Tab
This view provides more detailed control over the monitors. As detailed earlier, there are some
dedicated hardware buttons for monitor control which provide the most common sources. If the
operation needs to monitor other mixes, adjust the dimming levels, or adjust the TALK gains, this
is the location for those controls.
The gain indicators at the bottom are tied to the rotary encoders below. Additionally, touching the
display and sliding the finger to the left or right will also adjust the level.
In the Monitor Options page it is possible to set the source for the three Monitor Sections:
•
Control Room Headphones (CR HP)
•
Control Room Speakers (CR SPK)
•
Studio Monitors
For each one of these
sections, selectable with the
corresponding buttons, it is
possible to select different
sources to listen, such as
Program 1 to 4 bus, Record
and Phone bus, Auxiliary 1
to 8 bus, and three
EXTERNAL monitor inputs
available on the engine. In
order to assign a source to
the external inputs, press
and hold any of the EXT
buttons, and a popup list will
appear, presenting all the
sources which, in their
profile, have been
configured to show up as
externals.
Automix Tab
The view is divided in three
main sections:
at the top, the CHANNEL
SELECTOR section allows
to toggle selection of the
channels in the system and
to see which ones are
enabled into automix.
At the bottom left, the
CHANNEL PARAMETERS
section allows to change
the enable state or adjust
Advertisement
Table of Contents
