NOTE: Layers' configuration is saved inside each XR-4FAD fader module, and
therefore it is a global setting not stored in the MTS-MON module and therefore
not stored in Show profiles .
Enabling or Disabling Layers
Layers are enabled by default. If you use Layers, proceed to the next section
Layers.
If you do not use Layers, make sure they are disabled by following these steps:
Using a PC connected to your network, launch a web browser, and enter the IP address assigned
to the MTS module. Under the
In the UI Options section at the bottom of the page, select
click
Apply.
Other Configuration Options
Configuration
header, click on Customize.
Configuring
Disabled
from the drop-down list, then