Table of Contents
Advertisement
Program assignment & monitoring
Press the Program 1 key on the fader strip; it will illuminate to show you've assigned that fader to
PGM-1. Press the ON key at the bottom of the fader strip and move the fader up.
Congratulations: you've got audio on your main Program bus!
The meters on your display should be active, as shown below.
To hear the audio, make sure
you have selected Program 1
as source to your CR
Headphones or Speakers,
using the controls on your
Monitor module, and that the
volume is at an appropriate
level (the level meters
onscreen will show the relative
volume you've set). Also,
make sure the xNode feeding
your speaker has been
configured to the CR Monitor
source channel number.
Your setup is
complete!
That's it! You're ready to Rock
with Quasar!!!
Now, sit back and enjoy some
music. Try exploring the
intuitive UI of the Quasar
channel strip.... And have fun!
© 2016 Axia Audio - Rev 2.0
Advertisement
Table of Contents
