Table of Contents
Advertisement
On: Assigns fader strip to the specified Program or Aux Send bus upon Show Profile load.
•
Off: Removes fader strip from the specified Program or Aux Send bus upon Show Profile
•
load.
NOTE: Channels may be simultaneously assigned to any combination of Program 1 – 4 and
Aux Send 1 – 4 mixing buses.
Aux Send A-B-C-D Pre/Post Fader
Pre-Fader: Sends the input source to the selected Aux Send bus before fader gain
•
adjustment.
Post-Fader: Sends the input source to the selected Aux Send bus after fader gain
•
adjustment.
Aux Send A-B-C-D Pre/Post ON
Pre-ON: Sends the input source to the selected Aux Send bus before the channel's
•
ON/OFF switch.
Post-ON: Sends the input source to the selected Aux Send bus after the channel's
•
ON/OFF switch.
Aux Send A-B-C-D Gain
Select the Use: radio button to specify any additional gain or cut to be applied to the
•
assigned source before sending to the selected Aux Send bus.
Noise Gate Status
Bypass: Turns off the noise gate feeding the Vocal Compressor section.
•
Active: Turns on the Compressor noise gate.
•
De-Esser Status
Bypass: Turns off the Compressor De-Essing function.
•
Active: Turns on De-Essing function.
•
Noise Gate Threshold
Select the Use: radio button to specify the level, up to -50 dB, at which the Noise Gate
•
activates to attenu- ate input signals that fall below that level.
Noise Gate Depth
Select the Use: radio button to specify the amount, up to -30 dB, of attenuation to
•
Advertisement
Table of Contents
