Table of Contents
Advertisement
•
HP Mode: Selects the listen mode for the CR Headphones (Stereo, Left, Right, Mono
Sum).
•
Clear PFL: Lights up when any channel is assigned to the PFL bus. When pressed it will
clear the selection on all channels assigned to the bus. A quick fix de-select button.
•
Channel Select: Brings an option to select any channel from the touchscreen, as an
alternative to pushing the encoder located at the top of each fader strip.
•
Loudness Start / Stop / Reset: Controls the Loudness metering counters.
•
PFL to LS: routes the PFL (Pre-Fader Listen) bus to the Control Room LoudSpeakers out.
•
LS Mode: Selects the listen mode for the CR LoudSpeakers (Stereo, Left, Right, Mono
Sum).
Show Profiles Tab
A list of show profiles that have
been configured in the Quasar
Web UI will be presented here.
Select the desired show with the
touch screen and press the
LOAD SHOW button to the right.
Other buttons to the right let the
userperform the following
operations:
•
REFRESH LIST:
refreshes the list of the
available Show Profiles,
in case this has been
edited from the web UI
•
PAGE UP: pages up the
list
•
PAGE DOWN: pages
down the list
•
CAPTURE : takes a
snapshot of the current state of the surface, and stores the state in a new show. Once the
button is pressed, a dialog box pops up to enter the name for the new show
•
RENAME : changes the name of the selected show.
•
DELETE : removes the profile from the library of show profiles.
Note: If you think that the Delete Show button is too dangerous, and fellow operators
migh inadvertently delete important show profiles, you can always disable it from the
Web UI and make the button completely disappear from the touchscreen. The
functionality to delete shows will still remain available on the Web UI.
Advertisement
Table of Contents
