Vx System Integration (Multi Line) - Axia Quasar User Manual

VX System integration (multi line)

Multi line is the method most common in North America, where the operator has the ability to
choose between multiple incoming lines to feed the telephone hybrid. Commonly, two hybrids are
presented on separate faders, and the user dynamically switches between incoming lines. With
this method, you can use Show Profiles feature to instantly recall show setups that choose
between different phone systems, or even different phone system configurations.
For example, one Show Profile could call up the configuration needed for a Talk format, while
another might recall the configuration needed for music request lines, allowing a single studio to
be the Control Room for any station in a cluster.
Using this mode requires two steps: defining a Show Profile, then defining Source Profiles.
Show Profile Settings For Mulit Line Operation
Create a new Show Profile. If not familiar with how to do this, please review the instructions found
in the "Show Profiles" section of Chapter 2 of the Quasar manual.
The Show Profile configure page displays the name of the show, all the Channels (faders) of the
surface, above the channels are several additional items, one of which is the Phone Control link.
Select the Phone Cotnrol link to display the
following screen:
The Phone Type is where you select the protocol
used to communicate with the call server. Prior to the
VX system, the AP protocol was used. The AP
option is to support legacy Telos products still in use,
otherwise you would likely select the VX option.
The Phone Server IP is where you identify the IP
address of the Telos product that is managing the
calls. In cases where the non-default user name of
password is to be used, you would add those in the
text box. An example is
MyUser:MyPass@192.168.2.66 .
The Show Name field is used to identify a phone
system configuration when using a Telos VX system. These names are defined in your phone
system's setup. Enter the configuration name you wish to log into.
Note: with the VX system, this field can be left blank, permitting the changing of the show assigned
with a VSet phone, or the VX interface.
The Host / Studio Name field is used differently with different systems.