Table of Contents
Advertisement
Enter the number of the Engine input channel you want to assign to each physical fader for each
of the four Layers. The table shown in the picture above shows which input channel, of the 64
available in the Quasar Engine, will be loaded on each of the four channel strips each time you
press the LAYER 1, 2, 3, or 4 buttons on the Master Touchscreen module.
So, the fundamental difference between a Show Profile and a Layer is the following:
•
Shows are used to map input sources from your network to the input channels of your
Engine.
•
Layers are used to map the input channels of the Engine to the physical fader strips of
the Surface.
Here is an example of how to configure Layers on a 16-Fader console, in order to access all 64
input channels available in the Engine:
Fader Module # 1
Fader Module # 3
Fader Module # 2
Fader Module # 4
TIP:
This work can be done manually, by
typing the Input Channel number in
each field, or by using the +4 or -4
buttons
available the right edge of each layer.
These will increment or decrement the
channel assignments four at a time.
You can also go back to Defaults hitting
the Reset button.
Advertisement
Table of Contents
