Table of Contents
Advertisement
In the left column, click on Console Discovery menu. When prompted for authentication enter user
name "user", and leave the password field blank.
Here you will find all Fader modules connected to the Master, listed by their MAC and IP addresses,
which will be pre-assigned at the factory. If the pre-assigned addresses fits your networking scheme,
then you can skip to the next step.
In case you need to change these addresses according to your network scheme, you can assign a
new IP address to each module, by selecting it with the radio button, entering the desired address in
the box at the bottom and pushing the "Do It!" button.
Tip: We recommend choosing for the Master module an IP address with the fourth octed ending with
a 0 (zero), and an address with the fourth octet ending with 1,2,3,....etc for the first, second, third,
Fader module in your surface and so on. This will make easier to remember each module's IP
address for fast UI access.
Once all addresses have been set, please check access to each fader module by entering its IP
© 2016 Axia Audio - Rev 2.0
Advertisement
Table of Contents
