Replacement Of The Display Front Frame; Manpower; Tools; Preparations - GE Voluson i BT06 Service Manual

GE
D KTI106052, R
IRECTION
Section 8-12

Replacement of the Display Front Frame

8-12-1

Manpower

One person, 15 minutes
8-12-2

Tools

Phillips screwdriver 1 and 2
8-12-3

Preparations

1.) Power Off/Shutdown the system as described in
8-12-4

Display Front Frame - Removal Procedure

1.) With the LCD Display in open (upright) position, remove the screw cap from each of the 5 screws
(see:
Figure 8-37 remove screw caps and screws from the LCD Display Frame
2.) With the LCD Display in the fully open position, carefully release the LCD display frame from the
securing clips on all four sides. Use both hands to release and lift it away from the LCD display.
8-12-5

Display Front Frame - Installation Procedure

1.) With the LCD Display in the fully open position, return the front frame to the correct position. Using
both hands, press the frame under the securing clips on all four sides (see:
2.) Thighten the 5 screws that fasten the LCD frame in position and cover them with the 5 screw caps.
3.) Attach the correct naming sticker on the front frame of the Voluson i / Voluson e system.
8-30
10
EVISION
Figure 8-37 below) and then remove the 5 screws that fasten the front frame in position.
Figure 8-38 carefully remove the LCD Display Frame
Section 8-12 - Replacement of the Display Front Frame
Section 3-6-3 on page 3-72.
"naming sticker" on
display front frame
V i / V e
OLUSON OLUSON
S M
ERVICE ANUAL
Figure 8-38, above).