Micromeritics TriStar II 3020 Operator's Manual page 287

TriStar II 3020
4005- Pressures were not smoothed. Not enough pressures below 0.10
Cause:
Action:
4011- Analysis gas in sample file does not match any gas in the unit.
Cause:
Action A:
Action B:
4012- Psat gas in sample file does not match any gas in the unit.
Cause:
Action A:
Action B:
4014- File [name] is not a valid file for conversion.
Cause:
Action:
4015- Error creating export file for sample [file name].
Cause:
Action:
302-42828-01 - Dec 2013
The Smooth pressures below 0.10 P/P
Report Options window. There must be at least 10 pressures within
this range for smoothing to occur.
Deselect this option to disable this message.
The analysis gas specified in the sample information file does not
match the analysis gas entered in the Unit Configuration.
If the wrong adsorptive was selected in the sample information file,
change the adsorptive in the file.
If necessary, attach the appropriate gas bottle then enter the gas in the
Unit Configuration.
If using Measure psat of a gas in P
Conditions, the selected gas is not one of the selected gases in Unit
Configuration.
If the incorrect psat was selected, change the psat gas.
If the gas was recently connected to the instrument, update the Unit
Configuration.
The file selected for conversion is not a valid file.
Select only files that have been created by the proper program.
A file error occurred during creation of an export output file.
The output file name may be invalid. Ensure that the target directory
exists and is not full or write protected. The target disk drive may be
damaged or inoperative. Verify that other files may be created on the
same drive. Contact a Micromeritics service representative if this
error message continues.
P/Po
option was selected on the
o
and T options in Analysis
o
Appendix B
B-15