Micromeritics TriStar II 3020 Operator's Manual page 280

Appendix B
2493- An entry is required for this field.
Cause:
Action:
2494- Value is out of the valid range.
2495- Value is out of the valid range. Enter a value between [value] and [value].
Cause:
Action:
2496- Invalid number.
Cause:
Action:
2497- This field contains an invalid character.
Cause:
Action:
2498- The requested change to the Sample's status is invalid at this time.
Cause:
Action:
2499- Sequence number must contain at least 3 digits.
Cause:
Action:
2586- Sample file [name] has no pressure table entries.
Cause:
Action:
B-8
This field requires a valid entry to proceed.
Enter or select an appropriate value.
The entered value in the highlighted field is outside the valid range of
values.
Check the entry and enter or select an appropriate value.
An invalid number entered in the highlighted field.
Check the entry and enter or select a valid number.
An invalid character was entered in the highlighted field.
Check the entry and enter valid characters.
A request to change the file's status, for example, from automatically
collected to manually entered could not be done.
Contact a Micromeritics service representative if this error message
continues. Record the name of the sample file in which the problem
occurred.
An attempt was made to enter a sequence number that did not contain
at least three digits.
Enter a sequence number that contains at least three digits.
An attempt was made to start an analysis with an empty target
pressure table.
Add target pressures to the pressure table in the analysis conditions.
TriStar II 3020
302-42828-01 - Dec 2013