Micromeritics TriStar II 3020 Operator's Manual page 284

Appendix B
2522- Invalid controller application file.
Cause:
Action:
2523- Programming the controller failed.
2524- CRC check failed on programming controller.
2525- Unknown error programming controller.
2526- Controller download was not successful.
2527- Controller CRC error on boot block.
2528- Controller DRAM error.
2529- Controller Com1: error.
2530- Controller Com2: error.
2531- Controller debug port error.
Cause:
Action:
2532- The instrument contains a different software version. Do you want to reset it?
Cause:
Action:
2533- Analyzer initialization failed.
Cause:
Action:
2548- System status [n]
Cause:
Action:
B-12
The application's control file has been corrupted or deleted.
Reinstall the analysis program.
An internal processing and/or hardware error has occurred.
Contact a Micromeritics service representative if this error message
continues.
The application has discovered a different version of software
operating in the analyzer.
If there are no analyzers other than the TriStar connected to the
computer, select and allow the updated software to load.
Yes
An internal processing and/or hardware error has occurred.
Contact a Micromeritics service representative if this error message
continues.
There was a problem establishing communication with the analyzer.
Ensure that the communications cable is seated firmly in the Ethernet
slot at the analyzer connection and the computer connection.
Contact a Micromeritics service representative if this error message
continues.
TriStar II 3020
302-42828-01 - Dec 2013