Hrconf Identify; Hrconf Rescan; Hrconf Restore - Adaptec RAID 2045 User Manual

hrconf identify

Blinks the LEDs on a device(s) connected to a controller.
Syntax
HRCONF IDENTIFY <Controller#> LOGICALDRIVE <LogicalDrive#>
HRCONF IDENTIFY <Controller#> DEVICE <Channel#> <ID>
Parameters
Controller# is the controller number
LogicalDrive# is the number of the logical drive to be identified
Channel# is the channel number for the device
Device# is the device number for the drive.
Example
HRCONF IDENTIFY 1 DEVICE 0 0
HRCONF IDENTIFY 1 ALL

hrconf rescan

Enables the controller to check for the removal of any disk drives in the ready state, and to
check for the connection of any new disk drives to the controller. The command returns when
the rescan is complete.
Syntax
HRCONF RESCAN <Controller#>
Parameters
Controller# is the controller number
Example
HRCONF RESCAN 1

hrconf restore

Restores the controller configuration by importing it's configuration settings from a specified
file. Deletes the current configuration. The file must have been saved through the BACKUP
command from a controller of the same type, same number, and type of physical devices with
same channels and device IDs. A reboot is required for the configuration change to take effect.
Syntax
HRCONF RESTORE <Controller#> <Filename> [noprompt]
Parameters
Controller# is the controller number
Filename is the name of the file to read the configuration from
Noprompt: No prompt for confirmation.
Example
HRCONF RESTORE 1 C:\WINDOWS\HR2200 NOPROMPT
Chapter 2: Using the Command Line Utility
26
●