Setting Example For Alphanumeric-Type Data: Tag Number - YOKOGAWA ADMAG AXR User Manual

Major item
Sub-item
Parameter
Sub-item
Search Mode
selection (B)
Incorrect setting:
Incorrect setting:

5.3.3 Setting Example for Alphanumeric-Type Data: Tag number

This example describes the setting of the tag number for the alphanumeric-type parameter C10: Tag No. from
"FI-1101" to "FI-1201."
Setting mode
Start:
Major Item Major item
Parameter parameter
Search Mode
Setting mode
Major item
parameter
<5. BASIC OPERATING PROCEDURES
B23:Flow Span
120 l/min
SET
B:Easy Setup
22:Base Time Unit
23:Flow Span
24:Flow Decimal Pnt
B23:Flow Span
100 l/min
1200000 l/min
Rng:0.00001 32000
Out of range.
Touch any key.
B23:Flow Span
100 l/min
0001.0. l/min
Rng:0.00001 32000
Invalid value.
Touch any key.
F0505-2.ai
Setting mode
P:Protect
B:Easy Setup
C:Basic Setup
INC
Setting mode
B:Easy Setup
C:Basic Setup
D:Total Set
SET
F0506-1.ai
(USING THE DISPLAY UNIT)
When the switch is touched, the entire
SET
display flashes on and off. Confirm that the setting
has been correctly changed to "120," and then
fix this value by touching the SET
again.
NOTE
When no operations are carried out for 20
seconds in the flashing state, the system will
automatically return to the Sub-item Parameter
Search Mode.
When the operations except
out, the parameter cannot be set.
The system automatically returns to sub-item
selection screen (B).
NOTE
If the input value is outside the valid selection
range, the message "Out of range. Touch any
key." will be displayed. In such a case, touch
any switch to return to Parameter Replacement
Mode and redo the setting.
NOTE
If more than one decimal point has been input,
the message "Invalid value. Touch any key." will
be displayed. In such a case, touch any switch
to return to Parameter Replacement Mode and
redo the setting.
Setting Mode Condition
INC
switch to access C: Basic
Touch the
Setup.
NOTE
The ▲ and ▼ symbols to the left of the
parameters indicate that additional setting items
to those being currently displayed may also be
INC
selected. Use the
these items.
The cursor has been moved to C: Basic Setup in
this screen.
Touch the switch to enter C: Basic Setup.
SET
5-8
>
switch once
are carried
SET
switch to cycle through
IM 01E30D01-01EN