Table of Contents
Advertisement
Major item
Sub-item
Sub-item
Parameter
selection (C)
Search Mode
Parameter
Current setting value
Replacement Mode
Modified value
Current setting value
Sub-item
Major item
Parameter
Sub-item
Search Mode
selection (C)
<5. BASIC OPERATING PROCEDURES
C:Basic Setup
49:Flow User Span
10:Tag No
11:Flow Damping
Selection of the appropriate parameter
SET
C10:Tag No
Fl-1101
l-1101
DEC /SHIFT
X4
C10:Tag No
Fl-1101
Fl-1 01
INC
SET
C10:Tag No
Fl-1201
SET
C:Basic Setup
49:Flow User Span
10:Tag No
11:Flow Damping
108.0
FR
l/min
:
:
:
100
0
Fl-1201
TAG
F0506-2.ai
(USING THE DISPLAY UNIT)
Upon selection of C: Basic Setup, the cursor will
be positioned at C10: Tag No. (Sub-item selection
screen (C))
Touch the
switch to access Parameter
SET
Replacement Mode.
The cursor will flash on and off on the left of the tag
number. As "FI-1201" is to be setup in this example,
touch the DEC /SHIFT switch to move the cursor
to the position for multiples of 100.
At the position for multiples of 100, touch the
switch to change the "1" to "2." When the
INC
setting has been changed to "FI-1201," touch the
switch.
SET
When the
SET
switch is touched, the entire
display flashes on and off. Confirm that the setting
has been correctly changed to "FI-1201," and then
fix this setting by touching the SET
again.
NOTE
When no operations are carried out for 20
seconds in the flashing state, the system will
automatically return to the Sub-item Parameter
Search Mode.
When the operations except
out, the parameter cannot be set.
The system automatically returns to sub-item
selection screen (C).
After returning to Display Mode by touching using
the ( ESC ) twice as escape switches, it will be
possible to confirm the modified content (if Display
Select has been setup to display the tag number.)
Indicates selection of Tag No display for B42: Display Select3.
5-9
>
switch once
SET
are carried
IM 01E30D01-01EN
Advertisement
Table of Contents
