Handling Precautions; Checking Model And Specifications; Accessories; Storage Precautions - YOKOGAWA ADMAG AXR User Manual

2.

HANDLING PRECAUTIONS

This instrument has been inspected carefully at
the factory before shipment. When the instrument
is delivered, visually check that no damage has
occurred during transportation.
Read this section carefully as it contains important
information on handling this instrument. Read the
relevant sections for information not contained in
this section. If you have any problems or questions,
please contact Yokogawa sales office.
2.1 Checking Model and
Specifications
The model code and specifications are found on
the name plate located on the outside of the case.
Check that the model code and specifications
match what you have ordered.
Be sure you have your model number and serial
number available when contacting Yokogawa.
Figure 2.1.1 Name Plate (Integral Flowmeter Type)
<2. HANDLING PRECAUTIONS>
2.2

Accessories

Check that the parts shown below are included in
the package:
• Centering device (wafer type only): 1 pc.
• Plug: 1 pc.
2.3

Storage Precautions

If the instrument is to be stored for a long period of
time after delivery, observe the following points.
 The instrument should be stored in its original
packing condition in the storage location.
 Select a storage location that fulfils the following
conditions:
• A place where it will not be exposed to rain or
water
• A place subject to minimal vibrations or
shocks
• Temperature and humidity levels should be
as follows:
Temperature: -30 to 70°C
Humidity: 5 to 80% RH (no condensation)
The preferred ambient temperature
and humidity levels are 25°C and
approximately 65% RH.
 If the AXR magnetic flowmeter is transferred
to the installation site and stored without being
installed, its performance may be impaired
due to the infiltration of rainwater and so forth.
Be sure to install and wire the AXR magnetic
flowmeter as soon as possible after transferring
it to the installation location.
F0201.ai
2-1
IM 01E30D01-01EN