Chapter C: Computer Connections; Ethernet; Didapi Configuration - Planmeca ProMax Pan/Ceph Calibration Manual

Chapter
C
1

Ethernet

Connect a crossover cable to the Ethernet port on the back of the ProMax. (Figure 17)
Connect the other end of the crossover cable into the Ethernet port on the back of the
computer.
NOTE: If using a PCI card then follow the above instructions but instead use a PCI Interface Cable.
2

Didapi Configuration

Click Start , All Programs, Planmeca and then Didapi Configuration (Figure 18)
Printed copies of this document are considered uncontrolled.
22811.20.Rev001 07.31.2018
Computer Connections
Figure 18
Click on Ethernet Interface.
The default ip address is: 192.168.0.130
Click on "ProMax Open device config file" and type in:
Localhost=(ip address):5000
Save the file, click "Refresh" and close Didapi Configuration
- 17 -
Figure 17
17