Th Ball; Too Left - Planmeca ProMax Pan/Ceph Calibration Manual

NOTE: The new shoulder number should be lower than old number.
Press Lock and take the pin out and then press Done. Take another exposure
and check ball size again. If not repeat until correct size.
th
2.1.b 10
Measure from the center of the Center Ball to the center on the 10
the right then measure from the center of the Center Ball to the center of 10
Ball on the left. (Figure 82)
NOTE: From the Center Ball, the distance left or right to the 10
same.
2.1.b.i
Printed copies of this document are considered uncontrolled.
22811.20.Rev001 07.31.2018
Ball
Figure 82

Too Left

If the distance from the Center Ball to the left is more than the
right, then move the table away from the column. (Figure 83).
Figure 83
th
Ball will always need to be the
- 48 -
th
Ball on
th
48