Shadow Ball - Planmeca ProMax Pan/Ceph Calibration Manual

NOTE: Best way to adjust the table is to face the column with the table in the center of the body
and gently push or pull depending on what is needed. (Figure 86a-b)
Figure 86a
2.1.c Shadow Ball
NOTE: The oval above the Center Ball is the shadow ball. (Figure 87)
If the shadow ball is too left or too right, then go into Pan mode X-Collimator.
Printed copies of this document are considered uncontrolled.
22811.20.Rev001 07.31.2018
Figure 86b
Figure 87
- 50 -
50