Emerson Rosemount 5408 Reference Manual page 174

Specifications and reference data
February 2020
EN
• 1.4404 according to EN 1092-1 material group 13E0
JIS
• 316 SST according to JIS B2220 material group No. 2.2
• 316L SST according to JIS B2220 material group No. 2.3 (for protective plate design)
A.2.8 Conditions used for flange strength calculations
Table A-7: 316/316L SST (EN 1.4404) Flanges
Item
Bolting material
(2)
Gasket
Flange material
(3)
Hub material
(1) Only applicable to forged one-piece flanges.
(2) Not applicable to process seal antenna (features an integrated gasket). Use of extra gasket may result in faulty
installation.
(3) Only applicable to flanges with welded construction per
Table A-8: Flanges with Protective Plate Design
Item
Bolting material
(1)
Gasket
Flange material
Hub material
(1) Note that a minimum gasket thickness of 0.125 in. (3.2 mm) is required when using an air purge ring (option code
PC1).
174
ASME
SA193 B8M CL.2, SA193 B7
(1)
L7
Soft (1a) with min. thickness 1.6 mm
or
Spiral wound gasket with nonmetallic filler
(1b)
Stainless steel A182 Gr. F316 and EN 10222-5-1.4404
Stainless steel SA479 316 and EN 10272-1.4404
Table
ASME
SA193 B8M Cl.2
Soft (1a) with min. thickness 1.6 mm
or
Spiral wound gasket with nonmetallic filler
(1b)
Stainless steel A182 Gr. F316L/F316 and EN 10222-5-1.4404
SB574 Gr. N10276 (solution annealed condition) or SB164 Gr. N04400 (solution
annealed condition)
EN, JIS
(1)
, or SA320 EN 1515-1/2, ISO 3506 A4-70, or Bumax
(1)
88
Soft (EN 1514-1) with min. thickness 1.6
mm
or
Spiral wound gasket with nonmetallic filler
(EN 1514-2)
A-13.
EN, JIS
EN 1515-1/2, ISO 3506 A4-70
Soft (EN 1514-1) with min. thickness 1.6
mm
or
Spiral wound gasket with nonmetallic filler
(EN 1514-2)
Reference Manual
00809-0100-4408
(16)
®
Reference Manual