2Wire-2Line Service Mode - ZyXEL Communications P-793H v3 User Manual

Table 13 Network > WAN > Internet Access Setup (continued)
LABEL
Transfer Min Rate
(Kbps)
Standard Mode
Modulation
Apply
Cancel
Advanced Setup

6.2.1 2Wire-2Line Service Mode

The Service Mode section of the Internet Connection screen allows you to set up two DSL
connections when you select 2wire-2line mode. This allows you to create a point-to-2points
configuration.
Figure 29 2wire-2line Service Mode
The following table describes the labels in this screen.
Table 14 2wire-2line Service Mode
LABEL
Service Type
Service Mode
Service Type
Line1 / Line 2
Chapter 6 WAN Setup
DESCRIPTION
This field is enabled if Service Type is Server. Set the minimum rate at which
the P-79X sends and receives information. The actual transfer rate will be
between this value and the maximum transfer rate you configure.
When you select 4-wire in the Service Mode field, then the transfer rate you
set here is doubled. For example, select 192 Kbps to configure a minimum
transfer rate of 384 Kbps.
This field is enabled if Service Type is Server. Select the operational mode
the P-79X uses in the DSL connection. ANSI (ANNEX_A) refers to connections
over POTS and ETSI (ANNEX_B) refers to connections over ISDN lines.
Select the modulation supported by your ISP.
Click this to save your changes.
Click this to restore your previously saved settings.
Click this to display the Advanced WAN Setup screen and edit more details
of your WAN setup.
DESCRIPTION
Select 2wire-2line mode for the DSL connection. This means that the P-79X
is going to be a server connected to two client P-79Xs.
When you select 2wire-2line mode this field automatically changes to Server
or Client.
You can configure different connection rate settings for Line 1 and Line 2 DSL
connections.
P-79X Series User's Guide
50