Configuring A Server Behind Nat; Figure 278 Menu 15.2: Nat Server Sets - ZyXEL Communications ZyWall 35 User Manual

Internet security appliance

Hide thumbs Also See for ZyWall 35:

Table of Contents

ZyWALL 35 User's Guide

Table 181 Menu 15.1.1.1: Editing/Configuring an Individual Rule in a Set

Once you have finished configuring a rule in this menu, press [ENTER] at the message "Press ENTER

to Confirm..." to save your configuration, or press [ESC] to cancel.

34.3 Configuring a Server behind NAT

Follow these steps to configure a server behind NAT:

1 Enter 15 in the main menu to go to Menu 15 - NAT Setup.

2 Enter 2 to open Menu 15.2 - NAT Server Sets.

3 Enter 1 to go to Menu 15.2.1 - NAT Server Setup and configure the address mapping

rules for the WAN 1 port.

4 Select Edit Rule in the Select Command field; type the index number of the NAT server

you want to configure in the Select Rule field and press [ENTER] to open Menu 15.2.1.2

- NAT Server Configuration (see the next figure).

Enter the ending global IP address (IGA). This field is N/A for One-to-One, Many-to-One

and Server types.

If you do not assign a Default Server IP address, the ZyWALL

discards all packets received for ports that are not specified

here or in the remote management setup.

Menu 15.2 - NAT Server Sets

1. Server Set 1

2. Server Set 2

Enter Set Number to Edit:

Chapter 34 Network Address Translation (NAT)