Remote Node Filter - ZyXEL Communications Prestige 316 User Manual

Prestige 316 Broadband Sharing Gateway / Wireless LAN
The next table gives you instructions about configuring remote node network layer options not covered in
Table 5-3.
Table 5-4
FIELD
Rem IP Addr
Rem Subnet Mask
My WAN Addr
5.3

Remote Node Filter

Move the cursor to the field Edit Filter Sets in Menu 11.1, then press [space bar] to toggle and set the
value to YES. Press [Enter] to open Menu 11.5 – Remote Node Filter.
Use Menu 11.5 to specify the filter set(s) to apply to the incoming and outgoing traffic between this remote
node and the Prestige and to prevent certain packets from triggering calls. You can specify up to 4 filter sets
separated by a comma, e.g., 1, 5, 9, 12, in each filter field. The default is no filters.
Note that spaces are accepted in this field. For more information on defining the filters, please refer to the
chapter on filters. Note that for PPTP and PPPoE encapsulation, you can also specify remote node call filter
sets.
Figure 5-6
5-8
Remote Node Network Layer Options Menu Fields
If you have a Static IP Assignment, enter the IP address assigned to the remote
node.
If you have a Static IP Assignment, enter the subnet mask assigned to the remote
node.
Some implementations, especially the UNIX derivatives require the WAN link to
have a separate IP network number from the LAN and each end must have a
unique address within the WAN network number. If this is the case, enter the IP
address assigned to the WAN port of your Prestige.
NOTE: This is the address assigned to your local Prestige, not the remote router.
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters= 3
device filters=
Output Filter Sets:
protocol filters= 1
device filters=
Press ENTER to Confirm or ESC to Cancel:
Remote Node Filter (Ethernet Encapsulation)
DESCRIPTION
Remote Node Setup