ZyWALL Series Internet Security Gateway
Table 24-4 Advanced WAN Port Setup: Call Control Parameters
FIELD
Drop Timeout (sec)
Call Back Delay
(sec)
24.6 Remote Node Profile (Backup ISP)
Enter 2 in Menu 11 Remote Node Setup to open Menu 11.1 Remote Node Profile (Backup ISP) (shown
below) and configure the setup for your Dial Backup port connection. This feature is not available on all
models.
Rem Node Name= ?
Active= Yes
Outgoing:
My Login=
My Password= ********
Authen= CHAP/PAP
Pri Phone #= ?
Sec Phone #=
The following table describes the fields in this screen.
Table 24-5 Fields in Menu 11.1 Remote Node Profile (Backup ISP)
FIELD
Rem Node
Enter a descriptive name for the remote node. This field can be up to
Name
eight characters.
24-6
Enter a number of seconds for the ZyWALL to wait before dropping
the DTR signal if it does not receive a positive disconnect
confirmation.
Enter a number of seconds for the ZyWALL to wait between
dropping a callback request call and dialing the co-responding
callback call.
Menu 11.1 - Remote Node Profile (Backup ISP)
Press ENTER to Confirm or ESC to Cancel:
Figure 24-4 Menu 11.1 Remote Node Profile (Backup ISP)
DESCRIPTION
Edit PPP Options= No
Rem IP Addr= 0.0.0.0
Edit IP= No
Edit Script Options= No
Telco Option:
Allocated Budget(min)= 0
Period(hr)= 0
Nailed-Up Connection= No
Session Options:
Edit Filter Sets= No
Idle Timeout(sec)= 100
DESCRIPTION
DEFAULT
20 seconds
15 seconds
EXAMPLE
LAoffice
WAN and Dial Backup Setup