Registering Timers And Slope Control - YASKAWA YRC1000 Instructions Manual

4 Remote laser welding condition registration files

4.5 Registering timers and slope control

4.5. Registering timers and slope control
{START TIMER}: For the designated time period, the laser power remains OFF and the
laser stays in position at the registered start point until the specified period of time
elapses and welding begins.
{END TIMER}: For the specified time period, the laser power remains ON and the laser
stays in position at the registered end point until the specified period of time elapses and
welding ends.
{WELD START SLOPE}: Over the course of the specified slope, the laser power
increases from the specified start power to the specified laser power during welding. To
turn ON slope control, place the cursor over {WELD ST. ON/OFF}, press [SELECT], and
select ON.
{WELD END SLOPE}: Over the course of the specified slope, the laser power
decreases from the specified start power to the specified laser power upon welding
completion. To turn ON slope control, place the cursor over {WELD ED. ON/OFF}, press
[SELECT], and select ON.
4-45
HW1486273
45 / 95