Trumpf Pfo Head - YASKAWA YRC1000 Instructions Manual

8 S1E parameters

8.2 Trumpf PFO head

8.2. Trumpf PFO head
S1E Item
0 Laser application
specification
1 Laser power input limit Limits the laser power
2 Welding speed input
limit
8 Segment interrupt
mediation method
10 Servo delay time
20 Remote unit welding
start range: d1
21 Remote unit welding
start range: d2
22 Remote unit welding
start range: Z+ side
23 Remote unit welding
start range: Z- side
24 Remote unit motion
limit: d1
25 Remote unit motion
limit: d2
26 Remote unit motion
limit: Z+ side
27 Remote unit motion
limit: Z- side
28 Amount of
jogging/inching
movement
Details
Set when there is a laser
application.
input value.
Limits the welding speed
input value.
0: Mask method
(conventional)
2: Counter method (new)
Factors in a delay of the
specified duration.
Limits the welding start
point monitoring range.
(head Y-axis direction)
Limits the welding start
point monitoring range.
(head X-axis direction)
Limits the welding start
point monitoring range.
(head +Z-axis direction)
Limits the welding start
point monitoring range.
(head -Z-axis direction)
Limits the laser beam
motion range.
(head Y-axis direction)
Limits the laser beam
motion range.
(head X-axis direction)
Limits the laser beam
motion range.
(head +Z-axis direction)
Limits the laser beam
motion range.
(head -Z-axis direction)
Sets the amount of guide
laser movement for
inching during teaching.
Unit
* Unmodifiable 96
[W] Varies by
oscillator
specifications
[0.1 mm/s] Varies by
head
specifications
[ms] ON when
S1E46=0
(normally
S1E46=1)
[μm]
Varies by
head
specifications
[μm]
Set to match
the head
specifications.
[μm]
The welding
start range of
the remote
[μm] laser unit
should always
be set to less
[μm] than the
remote laser
head
movement
[μm]
limit.
When using
2D heads, set
[μm]
the Z-axis
direction
parameter to
[μm]
10000 [μm].
[μm]
8-80
HW1486273
Remarks Default
6000
40000
0
160
180000
50000
30000
-30000
240000
140000
40000
-40000
1000
80 / 95