Chapter 7: Rip Configuration Using The Acli - Avaya 8800 Configuration Manual

Chapter 7: RIP configuration using the ACLI

Use Routing Information Protocol (RIP) to perform dynamic routing within an autonomous system. This
section describes how you use the Avaya command line interface (ACLI) to configure and manage the
RIP on a brouter port or routed VLAN in an Avaya Ethernet Routing Switch 8800/8600.
This task flow shows you the sequence of procedures you perform to configure RIP.
Figure 19: RIP configuration tasks
RIP configuration navigation
• Job aid
• Job aid
• Configuring RIP globally
• Configuring RIP on an interface
• Configuring route redistribution to RIP
• Configuring interVRF route redistribution for RIP
• Forcing a RIP update for a port or VLAN
Job aid
The following table lists the RIP commands and parameters that you use to perform the
procedures in this section.
Table 17: Roadmap of RIP ACLI commands
Privileged EXEC mode
Configuration — OSPF and RIP
on page 99
on page 101
on page 102
Command
on page 103
on page 106
on page 108
on page 109
Parameter
June 2011 99