Dodge ZB 2005 Service Manual page 327

8L - 32 LAMPS
REPEATER LAMP - EXPORT (Continued)
INSTALLATION
(1) Install bulb to socket.
(2) Push lamp socket into the side repeater lamp.
(3) Position side repeater lamp to hole in hinge
cover.
(4) Push side repeater lamp to compress spring
clip and seat retaining tab into hinge cover.
(5) Verify lamp operation.
TAIL LAMP
REMOVAL
It is not necessary to remove the tail lamp unit to
change lamps.
(1) Open deck lid.
(2) Remove four bolts to battery compartment
cover and remove cover.
(3) Disconnect and isolate the battery negative
cable.
(4) Remove the two Torx head retaining screws to
the access panel of the respective side of the vehicle
and remove panel.
(5) Reach in behind the tail lamp unit and turn
the respective bulb counterclockwise, pull forward
and remove.
INSTALLATION
It is not necessary to remove the tail lamp unit to
change lamps.
(1) Reach in behind the tail lamp unit and place
lamp in socket, put in lamp unit opening and turn
the lamp socket clockwise until it locks into place.
(2) Install the two Torx head retaining screws to
the access panel of the respective side of the vehicle.
(3) Connect the battery negative cable.
(4) Place battery access cover into place and install
four bolts.
(5) Close deck lid.
(6) Verify vehicle and system operation.
TAIL LAMP UNIT
REMOVAL
(1) Open deck lid.
(2) Remove four bolts to battery compartment
cover and remove cover.
(3) Disconnect and isolate the battery negative
cable.
(4) Remove the two Torx head retaining screws to
the access panel of the respective side of the vehicle
and remove panel.
(5) Remove the three plastic retaining nuts retain-
ing the tail lamp unit into place.
(6) Reach in behind the tail lamp unit and turn
the lamp sockets counterclockwise, pull forward and
remove.
(7) Remove the tail lamp unit from the vehicle.
INSTALLATION
(1) Reach in behind the tail lamp unit and place
lamp in socket, put in lamp unit opening and turn
the lamp socket clockwise until it locks into place.
(2) Place the tail lamp unit into place and install
the three plastic retaining nuts.
(3) Install the two Torx head retaining screws to
the access panel of the respective side of the vehicle.
(4) Connect the battery negative cable.
(5) Place battery access cover into place and install
four bolts.
(6) Close deck lid.
(7) Verify vehicle and system operation.
ZB