Dodge ZB 2005 Service Manual page 325

8L - 30 LAMPS
MULTI-FUNCTION SWITCH - EXPORT (Continued)
Fig. 25 MULTI-FUNCTION SWITCH MOUNTING
1 - MULTI-FUNCTION SWITCH CONNECTOR
2 - HAZARD/WARNING SWITCH
3 - WINDSHIELD WIPER/WASHER SWITCH CONNECTOR
4 - MOUNTING SCREWS
5 - COMBINATION FLASHER
1 - MULTI-FUNCTION SWITCH CONNECTORS
2 - RETAINING SCREWS
Fig. 26 MULTI-FUNCTION SWITCH - REMOVE/INSTALL
REMOVAL
(1) Open deck lid.
(2) Remove four bolts to battery compartment
cover and remove cover.
(3) Disconnect and isolate the battery negative
cable.
(4) Remove both upper and lower steering column
shrouds.
(5) Disconnect both posi-lock harness connectors at
the rear of the multi-function switch (Fig. 25) and
(Fig. 26).
(6) Remove multi-function switch mounting screws
(Fig. 25) and (Fig. 26).
(7) The windshield wiper/washer switch must be
transferred to the new multi-function switch. (Refer
to 8 - ELECTRICAL/WIPERS/WASHERS/WIPER/
WASHER SWITCH - REMOVAL).
INSTALLATION
(1) The windshield wiper/washer switch must be
transferred to the new multi-function switch. (Refer
3 - MULTI-FUNCTION SWITCH
ZB