Dodge ZB 2005 Service Manual page 302

ZB
FOG LAMP UNIT - FRONT (Continued)
(2) Install three mounting screws attaching fog
lamp unit to front bumper fascia. Torque screws to 4
N·m (35 in. lbs.).
(3) Connect fog lamp connector.
(4) Install fog lamp access panel (Fig. 5).
(5) Connect the battery negative cable.
(6) Place battery access cover into place and install
four bolts.
(7) Close deck lid.
(8) Verify vehicle and system operation.
(9) Verify fog lamp aim. If adjustment is necessary,
(Refer to 8 - ELECTRICAL/LAMPS/LIGHTING -
EXTERIOR/HEADLAMP UNIT - STANDARD PRO-
CEDURE). At 25 feet on level surface, the fog lamp
beam should be 11 inches off floor on alignment
screen.
FOG LAMP - REAR (EXPORT)
DESCRIPTION
Rear fog lamps are used to make the vehicle more
visible from the rear during foggy or low light condi-
tions. The driver controls the rear fog lamp operation
through a switch located on the multi-function
switch.
FOG LAMP UNIT - REAR
(EXPORT)
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the bolts from the rear fog lamp
bracket (Fig. 6).
(3) Disconnect the electrical connector and remove
the rear fog lamp through the hole in the rear fascia
(Fig. 7).
INSTALLATION
NOTE: Only perform steps 2-4 if installing a new
wiring harness.
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the rear extension belly pan (Refer to
23 - BODY/EXTERIOR/BELLY PAN - REMOVAL).
Fig. 6 REAR FOG LAMP MOUNTING
1 - REAR BELLY PAN
2 - BOLTS
Fig. 7 REAR FOG LAMP IN POSITION
1 - REAR FOG LAMP
2 - REAR FASCIA
LAMPS 8L - 7