Dodge ZB 2005 Service Manual page 370

ZB
HEADLAMP WASHER NOZZLE - EXPORT (Continued)
Fig. 10 HEADLAMP WASHER NOZZLE
1 - BOLTS
2 - WASHER NOZZLE
3 - CLAMP
4 - HOSE
Fig. 11 HEADLAMP WASHER NOZZLE COVER
1 - COVER
2 - NOZZLE
3 - FRONT FASCIA
INSTALLATION
INSTALLATION - NOZZLE
NOTE: Right side is shown. Left side is similar.
(1) Position the washer nozzle and install the
bolts. Torque the bolts to 8 N·m (71 in. lbs.).
(2) Connect the hose and install the retaining
clamp.
(3) Install the front bumper reinforcement (Refer
to 13 - FRAME & BUMPERS/BUMPERS/FRONT
BUMPER REINFORCEMENT - INSTALLATION).
(4) Operate the headlamp washers and inspect for
leaks. Repair as necessary.
INSTALLATION - NOZZLE COVER
CAUTION: Be careful not to damage the front fascia
when installing the headlamp washer nozzle cover.
(1) Grasp the headlamp washer nozzle and extend
the nozzle out of the fascia.
(2) Align the cover to the nozzle and snap it in
place.
(3) Slowly return the headlamp washer nozzle to
its at-rest position, so the nozzle cover is flush with
the front fascia.
HEADLAMP WASHER PUMP
MOTOR - EXPORT
REMOVAL
(1) Remove the right front wheel and tire (Refer to
22 - TIRES/WHEELS - REMOVAL).
(2) Remove the right headlamp access panel.
(3) Disconnect the washer pump electrical connec-
tor.
(4) Disconnect the washer pump hose and remove
the pump from the reservoir.
INSTALLATION
(1) Install the washer pump into the lower reser-
voir.
(2) Connect the washer hose and the electrical con-
nector to the washer pump.
(3) Install the right headlamp access panel.
(4) Install the right wheel and tire assembly (Refer
to 22 - TIRES/WHEELS - INSTALLATION).
(5) Operate the headlamp washer and check for
leaks. Repair as necessary.
WIPERS/WASHERS 8R - 13