Setting Up The Asi Restamping Ts Output - Barco STELLAR User And Service Manual

N

Setting up the ASI restamping TS output

To set up the ASI
restamping TS output
When installed with the ASI restamping output option the S
transport stream recovered from the input.
Do as follows to set up the ASI restamping output:
1. From the Codec Explorer right-click on the ASI restamping output icon and
select Properties.
2. Click Restamping if your output frequency differs from the input frequency.
If you don't click Restamping the output frequency is identical to the network/TS
input frequency. Likewise, the output format is identical to the input format.
3. Set the format of the ASI output.
You may select between
• "188RSOFF" which means that the Reed Solomon algorithm is not applied,
• "204RSON" which means that the Reed Solomon algorithm is applied, and
• "204RSOFF" which means that there is not Reed Solomon algorithm applied
but there is RS overhead.
4. Set the bit rate of the ASI output.
The legal bit rate is 1 to 92 Mbit/s. The output bit rate must be equal to or higher
than the net bit rate of the incoming network/TS input.
Note! The ASI restamping output cannot remove programs from the net-
work input. This means the bit rate for the ASI output must be equal
to or higher than the net bit rate of the network input.
5. Accept the ASI mode "Packet" unless you have specific requirements.
Some non-BARCO decoders specifically require Packet or Byte mode. Set the
mode accordingly.
6. Click Apply.
can relay the full
TELLAR

Setting up the ASI restamping TS output

4
99