Setting Up The Individual Message Parameters - Barco STELLAR User And Service Manual

4
N

Setting up the individual message parameters

To set up the individual
message parameters
104

Setting up the individual message parameters

The individual message parameters only influence the selected message(s). Do as fol-
lows to set up the individual message parameters:
1. Select the relevant message group from the Group scroll list.
Only the messages belonging to the selected group are displayed.
2. Right-click on the mouse and select Reload Group.
This means that all messages belonging to the group are read from the S
and displayed in the list.
3. Select from the scroll list the message you want to set up.
4. Select Enable or Disable.
Disable means that the message is not shown in the ROSA message system nor
as an alarm in the alarm system (no relay contact is pulled).
5. Select the severity of the message from the Severity scroll list.
For each message you can select a message severity. The following categories
are available:
• Critical
• Major
• Warning
• Cleared
• Information
• Indeterminated
6. Select the alarm category from the Category scroll list.
Classify each alarm according to its importance. The alarm category denotes
which relay contact is activated. The A alarm is the most important and the E
alarm the least important one. For each of the three alarm sequences, each alarm
can be given a category to classify the alarm or it can be disabled.
Alarm sequence Available categories (relays)
1 A, B, C, Disable
2 A, B, Disable
3 A, B, C, D, E, Disable
7. Select the delay for the message from the Delay scroll list.
You can set a delay for each message in the range of 0 to 255 seconds. The delay
is common for the message and the relay. If you set the delay to 10 seconds you
get a message and the relays are only switched if the error condition has persisted
for more than 10 seconds. Likewise, the error condition must have been gone for
at least 10 seconds for the message to disappear and the relay to become inactive.
8. Right-click the mouse button and select Apply.
You may apply the "Selected Messages", "Current Group" or "Changed Mes-
sages".
TELLAR