Barco STELLAR User And Service Manual page 59

Select N x 64 PID
Description
Note!
The PID of the N x 64 data channel to be decoded. You select the
N x 64 kbit/s channel to be decoded by pressing the Enter key and
stepping through the list of available PIDs. If you select "Auto"
the S automatically decodes the N x 64 kbit/s channel with
TELLAR
the lowest PID. "Off" disables decoding.
To decode a "stand-alone" N x 64 kbit/s data channel you click
the Commands tab and type in the command
PROG:Nx64:SEL=MAN,PID. The manual selection is
particularly useful when you want to output an N x 64 kbit/s data
signal which is in the transport stream but not in the program.
3
47
Program selection