Rosa Messages - Barco STELLAR User And Service Manual

N

ROSA messages

Before you start
message list
No. Information
25 Audio output error Audio
decoding
error
6 Communication Cmd to
error missing
module
Command
not
supported
Command
syntax error
Improper
use of
command
Macro
already
recording
Max. macro
size
exceeded
Missing
comma
Parameter
out of range
Unknown
command
keyword
Value
truncated
Wrong
parameter
type
Messages from the S
TELLAR
The following shows an alphabetical list of the available ROSA messages and their
default status and an explanation to the messages
Name Enabled Severity
On Major
Off Information Disable
Off Information Disable
Off Information Disable
Off Information Disable
Off Information Disable
Off Information Disable
Off Information Disable
Off Information Disable
Off Information Disable
Off Information Disable
Off Information Disable
are shown in the C
OPERNICUS
Category Explanation/Remedy
A There is no valid audio output due to
decoding errors. Check the source and the
condition of the input signal
A command was issued for a module that
is not present.
The software of the decoder does not
support this command.
A syntax error is found in a command to
the decoder.
A module does not support the command,
or the command has been issued to a
module that is not present.
A macro is already being recorded. Wait
recording another macro unil the present
recording has finished.
You have tried to record more than the
maximum 256 characters. Try making the
macro shorter or divide your instructions
into two macros.
A comma is missing in a command.
Check the command reference.
A parameter within a decoder command
exceeds the range specified for the
command.
A keyword in a command is unknown to
the decoder.
An input parameter has been truncated.
You may get the actual setting by
reloading the relevant ROSA window or
by a query.
A parameter within a decoder command
has a wrong type.
5
explorer window.
123
ROSA messages