Setting Up The Synchronization Of The Video Output - Barco STELLAR User And Service Manual

4
N

Setting up the synchronization of the video output

To set up the genlock of
the video output
90

Setting up the synchronization of the video output

From this picture you set up the synchronization of the video output.
Do as follows to set up the synchronization of the video output:
1. From the Codec Explorer right-click on the video you want to set up and
select Properties.
2. Click the Synchronization tab.
3. Click the relevant video reference.
Locked means that the video output is locked to the encoder video input fre-
quency by using the PCR and PTS time stamps in the video stream.
Free running means that the video output frequency is not locked. Delay adjust-
ments of both video and audio will be performed to maintain the synchronization
between video and audio.
Note! This mode is useful if the S
locked mode (because of faulty PCR values in the transport stream).
Genlock means that the video output is locked to an external reference which is a
composite black and burst signal. The signal is applied at the REF IN connector
at the connector panel (option).
Note! The SCH phase of the composite output is not locked to the external
reference.
is always re-synchronizing in
TELLAR